ANEXO 1. PRACTICA DE ENSAYO DE TRACCIÓN
In order to make this test, traction or universal equipment will be used to realize traction, compression, flexible test, etc. This machine will be confirmed by one fixed support and another moving where test tube is stablished.
With the purpose of realizing this test we could be able to use two tubes types: plane and round. The procedure is completed in several stages:
1. It will be checked the correctly instruments condition
2. It will be sectioned the initial longitude calibration
3. It will be rightly putting together the tube above clamps or subjection system.
4. Afterward the broken tube confirmation will be taken the final measurements, putting together both parts. In order to measure its lengthening and determining the broken section dimension. Immediately, it will be realized relevant maths.
5. At the end, it will be cleaned and picked up the used equipment.